Can be used locally for walkways and higher trafficked areas where increased skid, impact and abrasion resistance are required, or for entire roof areas.
- Dry film thickness c.a. 4mm
- System weight c.a. 10.10Kg/m²
- Impact and abrasion resistant
- Low slip potential (PTV>36) based on HSE guidance (tested wet using Four S rubber (slider 96) on new indicative sample): PTV approx. 75
- High retention of PTV over time
- Available in a wide range of colours
System build-up
Primers (if required)
Cryl Primer 222
Primer for asphalt, bitumen, timber and other substrates.
Overcoat / traffic: 45 minutes
Consumption: 0.40Kg/m²
Cryl Primer 276
Primer for cementitious and other substrates.
Overcoat / traffic: 45 minutes
Consumption: 0.40Kg/m²
Primer 610
Primer for single-ply membranes, liquid coatings and coated metals.
Overcoat / traffic: 20 minutes
Consumption: 0.06L/m² min.
Metal Primer
Primer for metal substrates, also available as spray can.
Overcoat / traffic:
60 minutes using spray can
60 minutes using roller
Glass Primer
Primer for glass substrates.
Overcoat / traffic: 20 minutes
Consumption: 0.05L/m² approx.
Reinforced waterproofing (single process)
ProTect
Waterproofing resin used with Triflex 110g reinforcement.
Overcoat / traffic: 45 minutes
Consumption: 3.00Kg/m²
110g Reinforcement Fleece
Polyester fleece used with Triflex resins in Triflex fully and partially reinforced systems.
Embedment layer
ProTect
Waterproofing resin used with Triflex 110g reinforcement.
Overcoat / traffic: 1 hour
Consumption: 1.50Kg/m²
Aggregate Triflex Quartz 0.7-1.2mm: 6.00Kg/m²
Finish
Cryl Finish 205
Finish for Triflex roofing systems and walkway, balcony and terrace systems.
Overcoat / traffic: 1 hour
Withstand stress: 2 hours
Consumption: 0.60Kg/m²
Finish colours
Triflex ProTect with a heavy duty finish is available in a wide range of optional finish colours, allowing the system to be tailored to meet aesthetic and project needs. Special colours can be produced to order.